Manufacturing Process Planning Templates

Choose on any templates below.

	Flow Chart	Production Process Flow Chart, is a pictorial display of the sequence of actions taken in a process.
	PFMEA	PFMEA (Process Failure Mode Effect Analysis), is used to examine a process to identify where failures can occur and what the relative risks are for each failure.
	PCP	PCP (Process Control Plans), is used to document the method of controlling and assuring product manufacture to meet the intended quality standards.
	SWS	SWS (Standardized Work Sheet) that contains Takt time, template also contains cycle time combination sheet.
	SPL	SPL (Single Point Lesson), also called one point check sheet. Typically they are used to point out a single point usually quality.
	OPL	OPL (One point lesson), is simply a single piece of instruction focused on a single concept but located at the point of need at the time of need.
	JES	JES (Job Element Sheet), is a work instruction broken down into individual tasks.
	C.A.R.E.	C.A.R.E (Customer Acceptance Review & Evaluation) is used to protect your customer from non-conforming product, discrepancies and labeling errors.
	Visual Aid	Visual Aids or Checking Aids Sheets, is used to show with Images where key measurements are taken on the part.
	Work Instruction	Work Instruction, provide a detailed breakdown of instructions required to carry out one or more steps or tasks in a procedure.
	Defect Diagram	Defect concentration diagram, is a visual data display tool that shows where defects or problems are concentrated.
	Check Sheet	Check Sheet, is a document that is used for collecting data in real-time and at the location where the data is generated.

Production Part Approval Templates

Upon Request, Production Part Approval Templates have also been included in the Manufacturing Process Planning Template section. The templates below are used to measure production ready part specifications for reporting documentation purposes.

	Dimensional Results	Dimensional Test Results, is used to document the key dimensional characteristics of a production part at a normal production run of rate.
	Materials Results	Material Test Results, is used to document the key material composition of a production part at a normal production run of rate.
	Appearance Results	Apperance Approval Report, is used to document the key surface characteristics of a production part at a normal run of rate.
	Performance Results	Performance Test Results, is used to document the key operation characteristics of a production part at a normal run of rate.