One stop shop for all manufacturing charts, templates and statistical analysis
Complete in minutes
side bar spacer side bar spacer
 
Instant Download
Securely download your templates
TMSSonline Total Manufacturing Systems Solutions
The Complete Lean Shop
PayPal Logo
Satisfaction
Choose on any templates below.
Flow Chart
Flow Chart Production Process Flow Chart, is a pictorial display of the sequence of actions taken in a process. MORE INFO
PFMEA
PFMEA PFMEA (Process Failure Mode Effect Analysis), is used to examine a process to identify where failures can occur and what the relative risks are for each failure. MORE INFO
PCP
PCP PCP (Process Control Plans), are used to document the method of controlling and assuring the product is manufactured to meet the intended quality standards. MORE INFO
SWS
SWS SWS (Standardized Work Sheet) that contains Takt time, template also contains cycle time combination sheet. MORE INFO
SPL
SPL SPL (Single Point Lesson), also called one point check sheet. Typically they are used to point out a single point usually quality. MORE INFO
OPL
OPL OPL (One point lesson), is simply a single piece of instruction focused on a single concept but located at the point of need at the time of need. MORE INFO
JES
JES JES (Job Element Sheet), is a work instruction broken down into individual tasks. MORE INFO
C.A.R.E
C.A.R.E. C.A.R.E (Customer Acceptance Review & Evaluation) is used to protect your customer from non-conforming product, discrepancies and labeling errors. MORE INFO
Visual Aid
Visual Aid Visual Aids or Checking Aids Sheets, is used to show with Images where key measurements are taken on the part. MORE INFO
Work Instruction
Work Instruction Work Instruction, provide a detailed breakdown of instructions required to carry out one or more steps or tasks in a procedure. MORE INFO
Defect Diagram
Defect Diagram Defect concentration diagram, is a visual data display tool that shows where defects or problems are concentrated. MORE INFO
Check Sheet
Check Sheet Check Sheet, is a document that is used for collecting data in real-time and at the location where the data is generated. MORE INFO
Production Part Approval Templates

Upon Request, Production Part Approval Templates have also been included in the Manufacturing Process Planning Template section. The templates below are used to measure production ready part specifications for reporting documentation purposes.

Dimensional Results
Dimensional Results Dimensional Test Results, is used to document the key dimensional characteristics of a production part at a normal production run of rate. MORE INFO
Materials Results
Materials Results Material Test Results, is used to document the key material composition of a production part at a normal production run of rate. MORE INFO
Appearance Results
Appearance Results Apperance Approval Report, is used to document the key surface characteristics of a production part at a normal run of rate. MORE INFO
Performance Results
Performance Results Performance Test Results, is used to document the key operation characteristics of a production part at a normal run of rate. MORE INFO